![]() ![]() All interfaces are combined together as a single ‘internal’ interface. Here is a Fortigate device 80C which is in switch mode. ![]() You must disable the DHCP service on the FortiGate device and remove any policies attached to the hardware switch interface. Even if you do a factory reset of an existing device, it will revert back to these settings only. 1) Prerequisites to change the modeīy default, a brand new Fortigate Firewall comes in switch mode, default policy to allow Internet access, and DHCP to provide IP addresses. Configure the network and allow access to a particular network port.Change the mode from Switch to Interface.Three steps are involved in this process. If you need to delete the entire hardware switch and make all ports to interface mode, follow the below steps. Also, in this way, you can’t delete the entire hardware switch. There should be a minimum of one port part of the hardware switch.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |